Schlag
PC-DMIS demi-Guru
Last Activity: Today, 02:24 PM
Joined: 07-21-2010
Location: Alexandria MN
-
Run your program OFFLINE and see where all the features line up ? -
Calibration order
Interesting issue I am running into. After having to replace the computer on 1 of my globals I am trying to get it back up and running. I copied the probes...Last edited by Schlag; Today, 02:24 PM. -
A is off the CAD model because when you created your DATUM-A- from the CAD I'm guessing you missed the surface. When you brought in your step or IGES...Leave a comment:
-
It had a virus so they ended up re-formatting the hard drive. I'm sure something could still be recovered at that point but not they gave me the short... -
Ok. Talked to HEX.. Everything for my CMMs is actually saved on the Controler and not the computer. All i need to do is bring in the probe files...Leave a comment:
-
Completely wiped. Problem is I don't even know exactly what I need or should be looking for.... I currently work in ESTIMATING ! I estimating I am...Leave a comment:
-
Computer crash ! I lost it all !
On 1 of my CMM's we had a total loss of the computer. Long story short I lost everything. I have my probes backed up but it appears that I don't have... -
I would turn off the auto wrist angle feature. I never understood why you would need to add the different angles to a program ? More cal time is really...Leave a comment:
-
60 probe angles in 1 prg must be a monster !Leave a comment:
-
I personally always keep them the same to make it easier on my brain, but spot on, they don't have to remain the same ! -
Size ? Maybe what you are looking for is to use multiple planes at the same time ?Leave a comment:
-
Thanks for the clarification -
Based on your screen shots I would say that the angle of your arc segment using MIN_CIRSC is the problem. You say you "ALWAYS" have problems...Leave a comment:
-
Dont you need to have OVER 180° to use anything other than least squares ?Leave a comment:
-
The marked set must contain ( have marked ) anything that you need to execute the program. Clearplanes , movepoints etc. You are basically only turning...Leave a comment:
-
EDIT / MARKINGS / NEW MARKED SET. Before you do this open the MARKED SETS WINDOW. VIEW /OTHER WINDOWS /MARKED SETS WINDOW. Then you just mark...Leave a comment:
-
Start a new thread and otherwise no one else will see this.
If everything rotates 45° but the TRIHEDRON doesnt move tells me something... -
Take the part you need to check and all the gages that you currently use , place them in a clean and calibrated box then dump them on the table of the...Last edited by Schlag; 08-31-2018, 08:46 AM.Leave a comment:
-
If the orientation is correct /same as original just redo the manual alignment and answer NO when you get the alignment update question. OR, as everyone...Leave a comment:
-
If they were tolerenced back to something the FCF would reference another DATUM. I am going to disagree with you on this.
No activity results to display
Leave a comment: