Auto-calibration:
What are you using for parameters?
Have you tried adding 1 more level, or increasing the hits used to help drive the error...
R2ah1ze1l
Ultra Senior Member
Last Activity: Today, 12:15 PM
Joined: 02-03-2011
Location: Massachusetts
-
Can't you instruct your operator to rotate the part so the slot is at 6/12(closest/furthest from operator view) and just have the probe start at the slot?...Leave a comment:
-
Is this the only thing that you set in your PC-DMIS environment that 'reverts' from what you set it to be?
As a test, attempt changing the folder...Leave a comment:
-
$$ NO,
If you make the 'no' to a 'yes' it will appear in your report.Leave a comment:
-
Hit enter 2x before attempting to input an Assignment command. 1x will just move to the next row to continue typing your text. -
Use auto points and construct into a feature set. You can use the feature set in your DATDEF, or as a feature in an alignment.Leave a comment:
-
In your Theo line the .value should be .TX/.TY/.TZ/.TI/.Tj/.Tk In the actuals line you would just use the .x/,y/etc...
Or .x.theo/.y.theo/etc for... -
Geotol begins with 2020R2 and then later releases, 2020R1 and some prior have xact (I don't remember what version it started in) -
In current versions of PC-DMIS, you can use those planes to create 'width' features which will enable you to use Xact or Geotol reporting to obtain the...Leave a comment:
-
Basics are absolute, you would not rotate based on the 20.09º the part may actually be, the rotation in your alignment for evaluation would still be...Leave a comment:
No activity results to display
Leave a comment: