Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
I construct circles from Auto Points, and construct cylinders from those constructed circles and it analyzes the form of the cylinder using the points....
- 1 like
-
Are you using total runout or circular runout?
Circular runout checks the runout of the specified feature at different heights and evaluates...
- 1 like
Leave a comment:
-
If you are using more than one probe, make sure you say "Yes" when it asks if the sphere has moved for the first probe only. Do not move the...
- 1 like
Leave a comment:
-
It can be done, but I don't know anything about scripts and I'm pretty good with Excel, so I did it this way haha
-
This is a snippet of the sheet with all of the imported data. From here you build another sheet that's formatted how you want and populate that with...
Leave a comment:
-
This may not be quite the answer you were hoping for, but here it goes- I gave up trying to have PC-DMIS append a single file with all of the relevant...
- 1 like
Leave a comment:
-
When I have to reverse engineer something, I take all the measurements off the part with PC-DMIS and use the data to draw up the model in SolidWorks....
Leave a comment:
-
It should populate as the dimensions are executed in the program. I put all of my dimensions at the end of each program, so the report is not populated...
Leave a comment:
-
One time I got a literal napkin drawing with a Ø1/5in hole and a 8/32 hole. It was by far THE WORST "drawing" I had ever seen. I had to call...
-
The situation I am describing is for open-ended slots, O-ring grooves, etc. I am aware that slot features and circles will start from the center if the...
-
I have programmed slots that were only .010" wider than the 1.5mm probe tip I used to measure them. I just set the prehit/retract to half the difference...
- 1 like
Leave a comment:
-
Use cylinders. The entire feature must be within the true position tolerance and if you only check it at one depth, you run the risk of the other end...
- 2 likes
Leave a comment:
No activity results to display
Show More
Leave a comment: