Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
A lot of what a programmer can make depends on location, one's experience and capabilities. I work in the ortho world near Warsaw, IN and some of the...
- Likes 1
-
IMNSHO.... Each hole needs to have its own alignment based on the basic dimensions specified on the drawing, yes, 28 alignments including the 6° rotation...
- Likes 4
Leave a comment:
-
Aggravating that they took this option away and I can understand why based on what the AE told me but.... they should have set it to a specific radius...
-
What I've been playing with is using FASTPROBE and adjusting the TOUCHSPEED settings to reduce run times. I've gotten very good and repeatable results...
Leave a comment:
-
Fastprobe
I've searched the forum and can't find much on this and tech support hasn't responded to my case inquiry (it's been a week....) but I am wanting to know...Last edited by dwade; 05-16-2022, 12:00 PM.
-
Not sure what controller you have on your CMM but has FLYMODE been accidentally turned on? Some controllers won't support it and the probe will fail to...
- Likes 1
Leave a comment:
-
-
You might also try constructing 3D widths for your datum features
- Likes 1
-
In regard to Matt's response, has anyone crashed the CMM? It could be that the probe module is failing or your stylus is damaged in some way....
Leave a comment:
-
"Some improvement they did broke it ....." those are called undocumented enhancementsLast edited by dwade; 05-12-2022, 07:35 AM.
-
We don't use collision detection but use a parameter set for each probe so we can pick n choose what angles to run when. Collision detection doesn't always...
- Likes 1
Leave a comment:
-
I put the threaded knuckle in a small machinist's vise and then place the vise on the optical comparator and square up the pin hole used for the docking...
Leave a comment:
-
I believe that a width has to be constructed from lines or planes to have the software to be able to calculate a width
Leave a comment:
-
hello saw that you were online. i run PC-DMIS 2019 and was wondering if you new how large of a monitor you could use while not distorting PC-DMIS. i was...
-
I program offline with 2019R2 thru 2021R2 CAD++ on an HP ZBook running Win 10 Pro 64-bit system with 16GB RAM and an Intel i7 2.20 GHz processor. All...Last edited by dwade; 04-29-2022, 07:28 AM.
Leave a comment:
No activity results to display
Show More
Leave a comment: