Not as standard it doesn't.
Your fancy demo licence will have all the bells and whistles enabled, but we have to pay for stuff like that...
NinjaBadger
PC-DMIS Guru
Last Activity: Today, 07:33 AM
Joined: 05-09-2006
Location: UK
-
Ding ding ding ! We have a winner! -
A quick google throws up this https://www.convertcadfiles.com/
Never used it and can't vouch it's safe or works or anything but.... -
@minhcongddt98-gmail-com - You can'y within PC-Dmis, you need to get the CAD model transformed in the CAD software. -
I'm not saying you have to do anything.
I'm saying you could change the target vectors to approach the surface at an angle.
... -
Okay, so this is what's going on.
Profile is looking at deviation from nominal. It doesn't matter where you move your origin to, it's...Last edited by NinjaBadger; 11-14-2019, 08:21 PM.Leave a comment:
-
Not quite true. Your prehit needs to be big enough for the CMM to get up to speed it used during probe calibration. -
I just have the toolbars in the same locations I always have (no quick measure for me!)
My mouse moves to the right place on autopilot pretty... -
How did you get to this point?
Was this code created in the order it's shown? Or did you do the dimensions and then insert the offset alignment...Leave a comment:
-
Because people very rarely measure anything manually.
If your controller supports it then manual hits in normal (not slow) mode are most... -
As Matt is alluding to some probes will do this better than others. Also I believe some machine controllers just aren't designed for this.Leave a comment:
-
Did 4.0 ever even make release?
I remember testing it but I've a feeling that (in the UK at least) we deemed it unfit for purpose. -
One trick I have used in the past when measuring is small spaces, is to change the target vector (this is when using auto vector points).
...Leave a comment:
-
2010 was bad, I think anything before 2012MR1 (with the random exception of 2009MR1) was shocking.
There's lots of good new stuff in more...Leave a comment:
-
That's the thing right there!
If it's being done properly by everyone who uses it, this step isn't necessary, as the measured xyz offsets...Last edited by NinjaBadger; 11-13-2019, 10:58 AM.Leave a comment:
-
Sorry I wasn't clear - I wasn't saying it was wrong I was saying it was unusually slow and was wondering what the reason for it was.
If it... -
Anytime you unscrew any component of a probe you MUST re-calibrate it.
If you have a few modules I'd pick a useful tip that you use a lot... -
It will only remember the latest calibration - having two separate probe files (names) is an okay solution, but could you not just use 0.4mm/s for both?...Leave a comment:
-
I just want to make one thing clear here - you only need to employ a masterprobe when you're using multiple probes which are on separate modules....Leave a comment:
-
I'm with Ego on this one (about the cone being the datum) - there'd be no reason not to attach the datum letter to the gauge diameter.
I...Leave a comment:
No activity results to display
Leave a comment: