Smasherofprobes
Senior Member
Last Activity: 05-26-2023, 02:18 PM
Joined: 12-14-2022
Location:
-
We have both TTP and Analog heads here. Be aware if you have high vibration in your shop it can affect your analog system as it is much more sensitive... -
I figured so! Thanks -
It would be wrong to level to b1 and b2 right? Once i'm done programming this other hand I will mess around with this end of day. Thanks guysLeave a comment:
-
Should I be leveling to B1 and B2 also ?Leave a comment:
-
...Code:NET1 =FEAT/CONTACT/VECTOR POINT/DEFAULT,CARTESIAN THEO/<3802.923,-559.115,808.487>,<-0.791583,0,-0.6110617> ACTL/<3802.897,-559.185,808.651>,<-0.7917607,0.0019743,-0.6108283>
Last edited by Smasherofprobes; 05-18-2023, 11:03 AM.Leave a comment:
-
Liambo734 All the vectors for the nets are good to eachother and the surface vectors for the B1 and B2 match them. I am leaving everything as "Default"...Leave a comment:
-
For this alignment I am to Level to my 8 net points, Rotate between B1 and B2 and Origin B1 correct? No matter what I select i am getting errors. The...Leave a comment:
-
Thanks Kai! -
Matthew D. Hoedeman Unfortunately nobody in this company knows how to run a cmm machine, not even me!
I have nobody to answer my questions. Thanks...
Leave a comment:
-
Part alignment when datums are not locked to one axis
Hello all,
How do I go about doing a part alignment on this part? The part is sitting on a 45 between Z and X axis and I can't remember how... -
Individual trim points and a constructed circle/Midpoint? Is void detection throwing you off?
Could you not get your vectors from a surface...Last edited by Smasherofprobes; 05-16-2023, 02:12 PM.Leave a comment:
-
Could it be that you do not have your CAD surfaces selected? Under Graphics...Leave a comment:
-
I just jumped back on a machine after 7 years and I've found the best source of information is on Youtube. I guess if you are just learning you don't...Last edited by Smasherofprobes; 05-10-2023, 07:59 AM.Leave a comment:
-
Smasherofprobes commented on Smasherofprobes's to Problem with touch probe. Can someone help me ? :)If this is the issue could Kule8 not change 1 point then copy parameters for the sample hits?
-
Kule8 Are you using Surface points? Looks like it's taking 3 points for a surface point not sure if you are intending to use vector points. Either that...Leave a comment:
-
Thanks for your quick response, I thought the rule of thumb was whatever size ruby should be your touch speed 1mm = 1mm/sec , 2mm = 2mm/sec. I will have...Last edited by Smasherofprobes; 05-02-2023, 04:41 PM. -
HI guys, just me again. Im assuming with a 1mm Probe you use a 1mm/sec touch speed? (TTP TP20 Setup)Leave a comment:
No activity results to display
Leave a comment: