William Johnson
Senior Member
Last Activity: Today, 10:42 AM
Joined: 03-06-2006
Location: Florida
-
did you try to add a probe rotation when you have a program open? -
I have had issues with Xact measure using a Mid point to get the TP. I have seen it show .003" X dev when measured but Xact will show x=.000 dev...Leave a comment:
-
If you do not want to use the auto slot feature then I would measure the radius on the end of the slot. Set your (XY) origin on that then measure the...Leave a comment:
-
Very nice trick.Leave a comment:
-
Not familiar with active x controls. Sorry guys for being illiterate on this. Really busy right now so i will have to get back to this later....Leave a comment:
-
I do but apparently not enough. That or still feeling last night. I hit it heavy last night. Got home to find garage door wide open. Turns out when girlfriend... -
I did run as administrator for PCDMIS and verified that xcel was set to run as admin and still got same error. ??? -
AndersI good point not sure about that. I will check....Leave a comment:
-
I have full admin on everything....Leave a comment:
-
Sorry for the bad advice. I was not fully awake but no excuses. My bad....Leave a comment:
-
I would agree with you.Leave a comment:
-
Can only be to -A- on second component. -B- is not valid.Leave a comment:
-
It is set to my local printer. So I do not know what might work....Leave a comment:
-
Try constructing a projected circle from the cylinder. Then tolerance it. You will need to define the IJK and Dia, and .500 height for PT
...Leave a comment:
-
I did put all my programs in a specified directory and even changed the search path in PCDMIS. I do believe it is a Office issue. I'm told that I have...Leave a comment:
-
This is what I get when I run it. It will do the 1st program in the list with no probes or angles listed, then this pops up....Leave a comment:
-
Thanks i will check it out. I did a search of the forum and this did not come up....Leave a comment:
-
Global search for Probes used
Is there a way to do a global search for Probes used in your part program directory? I'm not looking for probe angles used just the defined probes. ... -
Would you then not need to calibrate in each version.? when you say save probe file in a different format. is there a way during or after calibration... -
I have a hasp dongle and running 2017 R2 with no problems. This is offline programming but they run fine on the CMM's
Question if you are...Leave a comment:
No activity results to display
Leave a comment: