S_Cliff
Junior Member
Last Activity: Today, 08:46 AM
Joined: 08-19-2020
Location:
-
If I change the initial offset to the input comment wouldn't it keep moving over my offset length every run? -
I'm a newb so I didn't think it would be as simple as /2 but I didn't know what else to try haha. I have a program for 1 part that I've looped with an... -
Nested Loop w/ an Input Comment
I have a looped program checking 2 parts. My goal is to use an input comment to keep the program looping and to measure the amount of parts I input.... -
Awesome! It worked! Thank you guys!Leave a comment:
-
Is this right? It's still doubling the total measured.
...Code:ASSIGN/NM=GETPROGRAMINFO("NUMMEAS") ASSIGN/OT=GETPROGRAMINFO("NUMOOT")Leave a comment:
-
Operator Comment in a Loop
I have a looped a program to run 2 parts at a time. I've inserted an operator comment towards the end of the loop to tell me how many dimensions measured... -
Changing the ID to NO worked! The ASSIGN/EFR=GETPROGRAMINFO("EXCEL_FORM1") was just me experimenting trying to get the Print Command to talk... -
I expanded my row height and the info is in fact missing. I tried running my loop over without any offsets. I ran the loop 4 times and I get the same... -
It still ends up saving like this, the first part saves fine but the 2nd part is missing the measured GD&T.
...Leave a comment:
-
I can't seem to get the Print Command and the Excel Form Report to work in concert. This is what I tried.
...Code:V2 =LOOP/START,ID=YES,NUMBER=2,START=1,SKIP=,
Leave a comment:
-
Does my Excel Form Report command count as a print command? I do have it placed before the end of the loop. For these particular parts I don't want... -
2 Part Loop with Excel Form Report
I have a program with a excel form report command at the end. I'm trying to loop it so I can do 2 parts at once. I've successfully looped it but when... -
I ran it offline and got zero deviation. I also flipped the part upside down so I could take the hits with A0B0 tip and it still measured out of tolerance....Last edited by S_Cliff; 10-09-2020, 11:17 AM. -
Ok I figured out it was already .005 from nominal because I had already ran my alignment. So maybe I just have a bad part...Leave a comment:
-
Trouble with a profile callout
I have this part. There is a .01 profile AB GD&T callout on the outside of the part. I selected 36 auto vector points on the CAD surface using 4 different...
No activity results to display
Leave a comment: