AverageInspector
Junior Member
Last Activity: 03-02-2021, 09:36 AM
Joined: 05-08-2020
Location:
-
I was recommended to report it, and made a case for it. Got tired of waiting for them to assign someone to the case and just gave up. Turned on R2 for... -
I will try that. thank you for the tip... -
If you redo the FCF dimension of the specific true position thats killing the program it won't repeat. Only works if you get to the dimensions before...Leave a comment:
-
Glad I am not the only one. So I take it from everyones replies the easiest work around is to ungroup (still causes crashes just less often) or use R2...Leave a comment:
-
AWESOME. I was hoping there was a backup. Made the mistake of opening a program to see the interface difference and then I couldn't open the R1 version... -
Neil,
If I open a part program in 2020 R2, would I be able to open that program in R1 or does it alter it so it won't allow an older ve... -
One thing I did notice was the consistency of the issues coming out of large programs that have group's within. I have a massive plate I did and I grouped...Leave a comment:
-
I haven't tried, but wouldn't that be a rather safe run as its not calculating actual data from the hits generated, if its not taking any hits? I run...Leave a comment:
-
True Position causing Crashes 2020 R1
Is anyone else experiencing PCDMIS crashing after running a repeat and proven program once it gets to the true position FCF at the end?
...
No activity results to display
Leave a comment: