Howdy
Ive got a question about best fit recomp constructions (specifically for construction of circles).
I read here on the forum that...
pcdmisstudent
Junior Member
Last Activity: Today, 11:08 AM
Joined: 08-07-2019
Location:
-
Question about best fit - recomp
-
Hey Jeff
Ok sorry for my lack of knowledge, but i dont got much experience with neither generic elements nor assign.
So i have my elements:... -
@VinniUSMC
No worries , Im just thankful for replies
The ruby tip im using right now is Ø4. The next biggest one is Ø6.... -
VinniUSMC
Sorry i dont really understand ur first sentence. The most i can measure of the circle is problably 180-200 degrees, if i measure it... -
So maybe i can just make a intersection point where the cylinders centerline intersects with the plane. And depending on the direction of the cylinder... -
Distance to highest point on plane
Hey guys
Ive think ive seen a couple of similar threads of this topic, but i havent really been satisfied with the responses.
I have...Last edited by pcdmisstudent; 12-05-2019, 10:56 AM. -
Using an "normal" tip
I havent calculated how much is between the probes and the wall of the cylinder. It seems to be very close (1-2mm),... -
Ah my idea was just to end the measurment program compeltely if the Ø35 was too small. -
Hey, i just noticed a problem.
I put the label at the end of the program, so even if the cylinder is above Ø35 and it measures the small holes... -
Ah i thought you had to assign it to some variable. Ill try that out later. Thanks a lot! -
Hey another question
Now if the cyl 35 is smaller than 35. can i report the measured value in a comment?
Like: assign/v1=cyl.D
... -
Merci Jeff!
That worked -
PC DMIS If commands
Hello all!
We have a part that consists of a big cylinder (Ø35mm). 45mm inside the cylinder theres two small Ø6 holes. I wish to measure the...Last edited by pcdmisstudent; 12-05-2019, 07:11 AM. -
So basically one point with 0, 52, 20, / 0,1,0 (XYZ/IJK), and then another point with 0,53,20, / 0,-1,0 ?
(im just curious if thats what you meant... -
Thickness of curved plate.
Hey guys
I have a part that i need to measure the thickness of
its 1mm thick and one side of the part has R105, the other side R107....Last edited by pcdmisstudent; 12-02-2019, 10:28 AM. -
So how would you recommend me to measure datum C? Circle,, construct offset point with radius as the previous guy mentioned?
And if so, how can... -
Hey how can i construct a point and assign it the value of the center + radius?
I could construct a offset point from the circle + radius. but... -
Weird datum
Hey guys
I have a weird datum that im trying to measure. (Ref C)
It seems to me to be the highest point (plane) at the curvature of a circle... -
Parallelism / sign at datum
Hey guys
i have a parrallelism on a surface to datum A
and at the datum it has the symbol " / 100"
If i remember it correctly...Last edited by pcdmisstudent; 11-26-2019, 09:25 AM. -
PC DMIS - Upgrading, benefits?
Hello all
We have been runing pc dmis 2010 since we bought this machine and we re currently discussing if we should upgrade to 2019.
Is 2019...
No activity results to display