Lukas
Member
Last Activity: Yesterday, 05:44 PM
Joined: 03-18-2019
Location:
-
So going from 2mm/sec to 0.5mm/sec helped a bit. A few tip angles came in tolerance (<.0003) but there’s still 2 tip angles that always give me .0004... -
Thanks for your input. This would really slow down our autocalibrate program. I'm honestly not sure what speed we measure at. -
touch speed is 2mm/sec -
0.5mm or 0.7mm probe calibration settings
I am using a 0.7X20mm probe (long thin shaft). What are the best calibration settings for this probe? It keeps failing calibration for a few tip angles... -
Thanks again. I agree. Sorry our prints are so wonky haha -
True position of an odd-shaped feature
Possible to do true position to ABC of an odd-shaped feature? It's a hexagonal-ISH (totally not symmetrical) shape and has taper in 3 dimensions. Maybe... -
Neil...as you suspected, there is perpendicularity of Datum B to Datum A on my print.
Can you please double check my work? I am totally new...Leave a comment:
-
MMB of Constructed Width
Can someone please give me brief steps on how to do MMB on a secondary datum using GeoTol or Legacy (doesn't matter). Right now the secondary datum is... -
I just downloaded the document thank you Neil -
Right, I just realized that I can't create a mid-plane for B because I don't have enough points to create planes on each side. I was thinking I could...Last edited by Lukas; 05-18-2023, 10:11 AM.Leave a comment:
-
Another Datum Target Points Disaster Print
Good morning all,
I am looking for some input on how you would program this. Datum A is the midplane of the part using target points at specified...Last edited by Lukas; 05-18-2023, 09:33 AM.
No activity results to display
Leave a comment: