Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Pierce Point
In 2016 cad++ I used to be able to construct a pierce point from an auto circle right on the tangency of the circle, in 2018 I noticed when I try this...
-
the pitch wont extend to the material thickness on the bottom, i can do two half circles, but when i try and construct one full out of the two halfs it...
-
its curved
-
Diameters on Angled Surface
So, I have eleven of these diameters on this angled surface I've tried a scan but it doesnt follow the contour of the I.D., I have a picture of an auto...
-
I tried that and its spins my trihedran im using a auto circle for C, if i construct a line from C to B and offset align that by 22.5 then it doesnt spin...
-
Strange Datum Targets Advice Welcomed!!!!
So, this datum target scheme I've never seen layed out this way before for datum D, I was going to go iterative for alignment, then what I was going to...
No activity results to display
Show More
Leave a comment: