A-machine-insp
Senior Member
Last Activity: Yesterday, 04:17 PM
Joined: 02-06-2018
Location: St. Louis area
-
I get the same issue and would also like to know how to lock the nominals in. Any print based part we get to make, our engineering department makes models... -
Just sent the entitlement ID Don. Emailed it.Last edited by A-machine-insp; Yesterday, 01:57 PM. Reason: Forgot to add how I messaged it... It's friday. -
I always send the crash reports but I didn't input my email. I have the entitlement ID if that helps. -
When you get back to work, post the code from your DCC alignment. It seems like there mat be an avoidance move on that could be causing your original...Leave a comment:
-
When using an iterative alignment, I set a clearplane after the manual and use a clearplane command for every hit used in the iterative alignment. Once... -
Do you have a completely written program or are you starting to write the program? If you are just starting to write the program then I would (and do)...Leave a comment:
-
When I get some time (rare) I'll make a program using the hex block (all of our stuff is export controlled) to recreate the issue and send it to you. -
Highlighting and using backspace is working for me now. The crashing has stopped.Leave a comment:
-
B&S Global Advantage, Renishaw PH10MQ, SP25M with a TM25-20 and a TP20. Usually running a 2mm x 80mm probe. -
Where is your C1 Input at?Leave a comment:
-
I do what Schlag does but I have it saved as Template Program. I also use read points to start a lot of programs instead of manually taking hits so I...Leave a comment:
-
Correct. The only way I can keep dimensions off of the excel is to use NONE for report output. -
Thanks for the great explanation. Now, maybe I can get the other programmer to quit using Legacy with modifiers. I keep telling them that Legacy doesn't... -
I commented my results on each idea that I tried from this post. The only thing that has worked so far is opening my new program template, saving it with...Leave a comment:
-
Just tried this too and it also crashes on me as well. -
Just tried this and it crashes as well. -
Yes. I have programs that are in 2018 R1 format as well as 2019 R1 format and they all do it. -
Usually a couple hundred points. We have parts that come in with tooling tabs on them so when they come in with them removed, we only have to check the... -
It has done it on every program we have needed to do this on. I think shelling it is going to be the answer. -
Mass delete crash 2019
I'm having an issue where when I go to delete the entire program ,except the alignments, DMIS either does nothing or crashes. All I'm doing is highlighting...
No activity results to display
Leave a comment: