Kai Kendall
Senior Member
Last Activity: 05-26-2023, 06:26 PM
Joined: 12-28-2017
Location:
-
This mostly depends on shaft diameter and material, but when things get very flakey, or if you have a thin part: touchspeed 1.0, Max force 0.024N, Low... -
1) I'm not aware of any canned method that satisfies every circumstance (not just Quindos, but in any CMM software). However, IF, you have only one characteristic,...Last edited by Kai Kendall; 05-24-2023, 07:03 PM.Leave a comment:
-
Could a probe be taking false hits in air, particularly on alignment features? Heavy stylus/low trigger forces?Leave a comment:
-
Yes, Trax, is another way to correct the it's-not-a-bug. -
Scanning is useful, since it gathers thousands and thousands of points in a few seconds. This particular software is structured in a way that slows it...Leave a comment:
-
Click in feature that drives graph, hit F9 (edit), do nothing, close dialogue box, now it's fixed (one time). Hexagon gets very offended if you imply...Leave a comment:
-
Usually derived from ISO/ASME fit tolerances. Another similar case might be bearing surfaces, for similar reasons....Leave a comment:
-
If this is a casting with defined casting datum targets you would have to use iterative alignment (and be sure to enter all values exactly as they appear...Leave a comment:
-
This can happen with heavy stylus systems. Turn down accelerations (you would type ACCELERATION/MAXACCELX=5, MAXACCELY=5, MAXACCELZ=5, or whatever values...Leave a comment:
-
Cylinder, convert to points, delete ones in the air, or too close for comfortLeave a comment:
-
You can, then, do something with IF/THEN logic -
To get the correct roundedness, you would multiply, round, then divide. -
There's a "ROUND()" function. Seems to work, you can be creative and use it to accomplish your goals:
PNT_TEST_1 =FEAT/CONTACT/VECTOR...Leave a comment:
-
Some agencies actually specify what he is looking for. -
There's a copper ring under the stick. You can try cleaning that. It's been a while, but getting the old grease out of there helps sometimes.
...Leave a comment:
No activity results to display
Leave a comment: