LaserJay
Senior Member
Last Activity: Yesterday, 04:59 PM
Joined: 06-28-2016
Location: DFW
-
Example Programs* -
I love the fixed radius / small arc analysis!
If you go to the pcdmis home page > discover tab > example routines > there are examples... -
My favorite is "Do you really need the CMM to check that part? It would be an easy height gage check"
(Part has like 8 holes that...Leave a comment:
-
Also look in to read point alignments, they can change your life! Anyone who operates your programs will thank you as well if you have good explanations...Leave a comment:
-
Yeah you can avoid doing the manual hits if you have fixturing that allows you to generally repeat your setup. I use rayco fixtures so it is very common...Leave a comment:
-
Have you tried doing a 3d distance instead of 2d feature to feature. I know It is likely more correct to be 2d feature to feature but it might resolve...Leave a comment:
-
You could also try the notch feature instead of a slot. I have never used it personally but your feature looks more like a notch than a slotLeave a comment:
-
Childish. just childish LMAO -
It is very fast.
It just drops to the top of the hole, wiggles a bit in X&Y and moves up. takes maybe 2 seconds....Leave a comment:
-
Small diameter hole location with self centering point
Has anyone ever done this?
We have a part with a Ø 0.0115in hole that has a .005 true position. I was going to check it on the comparator but I... -
Yeah I think you are having paralysis by analysis on this one. There is nothing wrong with using vector points instead of scanning. Yes scanning is more...Leave a comment:
-
I use a 12MM disk very frequently (for the same thing, seal grooves) and I also have a 30MM ceramic disk that I have to take out on occasions. The 30MM...Leave a comment:
-
Tuesday. AKA Monday number 2.
We all need a good joke every now and then to get us through the pain of a work week lol -
Hit F5>General>Warnings and see if there are any warnings turned on or off for your safety moves or collision detection.
Whenever you hit...Leave a comment:
-
Dawn of the dead post.. lol If AndersI is one of the last comments you know this post is old
Welcome to the forum!...Leave a comment:
-
I don't think the ASME refers to any specific rules regarding datum shift
5.3.2.2 (1994) defines how to apply datum shift but it doesn't put any...Leave a comment:
-
Do you do a lot of scanning. My system will hang up sometimes after a heavy scan. I have a cone that I scan that is pretty dense and my system always...Leave a comment:
-
Do you have a VIEWSET in your program?...Leave a comment:
-
Noice! Sometimes I miss writing programs that take 2-3 weeks. Only sometimes.
I am the only programmer at my company right now so if I was...Leave a comment:
No activity results to display
Leave a comment: