ctw00
Member
Last Activity: Today, 03:41 AM
Joined: 06-20-2016
Location:
-
While looking through the Hexagon Idea Center it looks like someone requested this feature, and it is included in PC-DMIS 2020 R2. https://hexagonmi.... -
How fast is 100% on your machine? The machine I am using 100% speed translates to 300mm/sec. With my 1x10 probes if I went faster than 1.5% (4.5mm/sec)... -
If 'Fit to Datums' is on it will adjust the position until the deviations are at zero. Fit to datums is great if you just want to know if its a good...Leave a comment:
-
What are your speeds and settings for the verification? I'm using an L probe, 50mm extension with a 2x20 stylus and it regularly says .0001-.0002 std...Leave a comment:
-
It happens to me every once in a while in 2018 R2, mainly if I copy and paste a feature, but not nearly as much as 2016 or earlier. -
Datums aren't required for coaxial features as his was drawn, they just have to measure good to each other. (In ASME Y14.5-2009 it is covered under '7.6.2.3... -
Scott, make or copy a new blank program and open it. Open the program you are having problems with and selected everything in the problem program from... -
I needed to something similar but a bit more complex, I had 4 fixtures in a 2x2 pattern with 2 rows of parts in the Z direction holding parts, naturally...Leave a comment:
-
Hexagon got back to me to let me know that this machine shipped without temperature compensation.Leave a comment:
-
The error was because the 'Reference temperature','High threshold', and 'Low threshold' fields were blank, so the 20C temperature was not between the... -
This controller is serial based, so I think I would need to figure out the correct command for that.
That 20.0C readings are what had me...Leave a comment:
-
I have the same results if I click that. -
It gave an error saying the temperature reported was outside the limits, I changed the threshold values to match the others and the error doesn't come...Leave a comment:
-
I'm not sure, the machine was built in 2003, I don't know if it was purchased by the company new or used. Everyone that would have been here at that...Leave a comment:
-
Am I correct in assuming that since we have a temperature sensor that the machine was likely ordered with temperature compensation at the time?...Leave a comment:
-
I actually opened a support case up with Hexagon a week ago....Leave a comment:
-
I don't have a Thermal_OCX folder or a serv1.stp file anywhere on this computer. I'm also not sure if this is the original computer for this CMM as that...Leave a comment:
-
Temperature Compensation
How can I tell if our machine supports temperature compensation? We have a Brown and Sharpe Global FX 777 with a DEA control box and what looks to be...
No activity results to display
Leave a comment: