Jignesh
Senior Member
Last Activity: Yesterday, 09:44 PM
Joined: 01-03-2016
Location:
-
Yes. If I measure all 4 holes at once in Feature control frame, it gives True position with correct measured values of all 4 holes at once. Let me have... -
I can attach drawing later tomorrow if it is necessary for review....Leave a comment:
-
True position for only one feature has to be done by Legacy.
I am having some drawings in which base of the part is primary Datum-A. Datum-A is having 4 same diameter holes. I find center of patern of 4 holes... -
Thank you....Leave a comment:
-
Sorry,
correction: Manual mode: PLN1, Lin1, Lin2.Leave a comment:
-
Adding point in alignment.
Manual mode: PLN1, Dclin1, Dclin2.
DCC Mode: Dcpln1: z+ level. Dclin1: x+ rotate, Dclin2: x=0.
Is it possible to add one more point in Dclin2... -
Thanks vpt.se. I appreciate you.Leave a comment:
-
I have only one question about it. It would have solved the issue. In fact, this True position with out Datum is the True position between slots....Leave a comment:
-
Hi M Baroni. Could you please just right in reply how I can create the third true position 0.2 with no Datum. I mean I would need to follow same procedure...Leave a comment:
-
True position with no Datum.
The drawing shows True position of all slots with no Datum. Is it possible to find with out Datum? I created other True position, but I have not... -
Sorry friends. I was at work. Actually, MID line coordinates were not right what they should have been. So, it was the problem. My program however...Leave a comment:
-
I have to create Mid line of two lines to make a Datum. So, I created SCN1 from two lines in Construct feature set. The theoretical average coordinates...Leave a comment:
-
Construct feature set
Is it okay to use construct feature set SCN1 as a Datum? -
I am away from desktop, and I could not open your file in phone. Actually, when I used construct feature set and created SCN1 at the center of Mid of...Leave a comment:
-
I tried to find True position of individual slots. They are meeting specification by picture of location shown in report window. But measured value...Leave a comment:
-
I put the part up side down on the fixtures because Datum-A is located at bottom of the base. I created line at both sides of the base those are 116mm....Leave a comment:
-
I think My version does not let me find all three True position at once in one Datum feature frame....Leave a comment:
-
I work in PRO.Leave a comment:
-
The new version was installed in 2017. Do I need to find all true position at once? My inspection plan indicates to find 0.2 A,C separately for the...Leave a comment:
-
I could not attach the whole drawing because of so much MB, but I attached different part of the drawing. What is Xact?...Leave a comment:
No activity results to display
Leave a comment: