acgarcia
PC-DMIS demi-Guru
Last Activity: Yesterday, 05:44 PM
Joined: 10-13-2015
Location: South Texas
-
DAN_M Thanks for the help. I got some work to do.... -
DAN_M How would cross section 2 give you a value of 0.0008? Asking honestly....Leave a comment:
-
Thanks for the info DAN_M as this always confuses me. Due to the size of my Datum A which is like 8 inches in diameter by 8 inches long, and my runout...Leave a comment:
-
Automate, automate, automate. We try to have the human do less and less with the CMMs. All they can do is load/unload parts, open/run protected programs,...Leave a comment:
-
Symbol on the print is a single arrow.
We actually indicated a part this morning still in the machine. The feature that reports out of tolerance...Leave a comment:
-
I have considered this in the past. Just curious. So if 1 or more items are out of tolerance and you don't have have a report to review, how will production...Leave a comment:
-
I suppose that's the next step... -
That makes sense. I though about checking my runout features as cylinders but there isn't exactly a lot of meat on them, my CMM head will hit other surfaces... -
So here's an pic of what i'm checking. FYI, this program has been running on the CMM for 2 years and the parts were 95% good. Part was moved to...Leave a comment:
-
Runout - Axial vs Radial
I have a part that is constantly out of tolerance on radial runout. My datum is a cylinder and my runout feature is a circle. When I change runout from...Last edited by acgarcia; 11-29-2022, 11:28 AM. -
Thanks for the info everyone.Leave a comment:
-
Using an extend force, 20mm ext, 5 way, tip1 3x20mm, slot 2 tip2 3x20mm, slot 4, tip 3 3x20mm.Leave a comment:
-
In the past, without removing the part from the CMM, the results are repeatable. The diameter of the cylinder is around 8 inches and is about 7 inches...Leave a comment:
-
Liambo734, I skip the manual alignment and go straight to dcc with those points and then use that cylinder in my alignment. That could be the culprit...Leave a comment:
-
constadin, I don't have much experience using graphical analysis but i'll play with it. I was thinning of reporting t values of each of the points as...Leave a comment:
-
Probe Calibration and Form Resutls
Can probe calibration affect form results?
Using TP20, 3 way (T-shaped) build. Taking about 50 vector points around a cylinder and constructing...Last edited by acgarcia; 11-17-2022, 11:12 AM. -
I think quick features need to be set up in the strategy editor before you use them. Auto plane is not very user friendly. I use auto where i'm probing...Leave a comment:
-
steelweaver120 Keep this in mind when you are changing probe lengths and such. Each force module has a maximum length. I'll admit I might have made some...Leave a comment:
-
Keep in mind that your CMM has to have the license set up for a probe rack. You'll have to pay hexagon a license fee if its not already on there. Also... -
Under 5 hits, you have a depth setting. I like to make my depth 0. You need to adjust your XYZ values on the top left and then make sure you select inner...Leave a comment:
No activity results to display
Leave a comment: