BKulpa, JEFMAN
At my previous workplace I noticed a similar issue but the other way around.
I compared the auto center scan to the...
Aaron Baldauf
Member
Last Activity: Today, 09:26 AM
Joined: 08-07-2015
Location: Switzerland
-
Last edited by Aaron Baldauf; 04-14-2021, 04:13 AM. -
Ajesh George
One more thing to keep in mind. PC-DMIS doesn't use the same calculation method for GX and GN (size command) vs max inscribed...Leave a comment:
-
Ajesh George
I don't think so, at least i haven't found out.
What I usually do is look at the graphical analysis (with high multiplier)...Last edited by Aaron Baldauf; 03-18-2021, 06:51 AM.Leave a comment:
-
Regarding the LP
Think of it as measuring the part with a 2-point-micrometer.
You measure the part in different locations and get different...Leave a comment:
-
neil.challinor
Don Ruggieri
Regarding Neils comment number 11.1.
Is there a reason that PC-DMIS even allows these characters...Leave a comment:
No activity results to display
Leave a comment: