i found your problem. How bout you contact the customer and find out the answer instead of guessing.
Nowadays the CAD is used as the Master. Measure...
BIGWIG7
Ultra Senior Member
Last Activity: Yesterday, 07:46 PM
Joined: 11-24-2014
Location: Los Angeles
-
Last edited by BIGWIG7; 06-15-2018, 02:15 PM. -
Move the part somewhere else on the table and run the part and see if you get the same error. You could be getting ghost hits in that particular area...Leave a comment:
-
*throws hands in the air* -
next time tell us what system you are using. -
you have a curved surface.
if you need to rotate the probe do so so that the probe tip is as normal to the surface as possible.
turn your...Last edited by BIGWIG7; 06-07-2018, 07:43 PM.Leave a comment:
-
+1 thats how i do it. -
set up a hidden camera and catch them fools on tape....Leave a comment:
-
i have a man crush on you davehocum. -
good grief that looks like a lot of work. I take a damned picture of my setup with my camera phone and put it in a comment at the beginning of the pr...Leave a comment:
-
But you gotta admit that berating your management is WAAAAAY more fun....Leave a comment:
No activity results to display
Leave a comment: