KIRBSTER269
PC-DMIS demi-Guru
Last Activity: Today, 04:20 PM
Joined: 07-03-2014
Location: Illinois
-
oh ok, gotcha ya, Well Hexagon did call me back, but @ 6:00 in the afternoon, didn't talk to them. Let's see, oh yeah I have a life, anyways no answer... -
I just noticed you said scans not scan. It would let me do several scans, each one maybe 3000 here, 3000 there, It was a single long scan that had over... -
-
I'll take a looksy, probably can't check till tomorrow. I can group them together well over 20000 hits. Just can't do it in a single scan -
Unless you built it wrong, Your first Tip 1A0B0 would be at 3:00, 2A0B0 12:00, 3A0B0 9:00, and 4A0B0 would be at 6:00. Also if your Probe is built correctly,...Leave a comment:
-
Sit UBU Sit, good dog -
Hey old dog, if your owner continues to put water in the dogs bowl and it's always been fresh clean water, but you see other dogs drinking out of a dirty... -
Well I created smaller Open Linear Scans with about the 3rd of points produced, and it works fine. Me thinks the piece of sh_it computers that Hexagon...Leave a comment:
-
hmmm the only difference p620 video 2 gb and windows 10 wouldn't think video but possible. updating driver right now -
What are your specs on your PC? Something I can compare to. -
I'll double check there, thanks for the 2 cents
-
First Time seeing This Error from Scanning
Alright Folks has anyone seen this Error. I'm guessing the computer can't handle my scan. It has 12344 Hits on a Closed Scan 2018R1 SP8. Any one have... -
If you put your mouse right on that label and right click on it, you can hide the datum Shift. I don't think it sticks everytime you run it so you might...Leave a comment:
-
I am not sure exactly what you're asking, but Legacy is based off of how you aligned your part, you know your 321 alignment, so say you level to let's... -
Is there anyway you can share the Datum structure or even the print and callout?Leave a comment:
-
Arguing with an engineer is a waste of time, even if you show them proof. They don't believe you, because they THINK they don't make mistakes. Ask them...Last edited by KIRBSTER269; 06-14-2019, 12:33 PM.Leave a comment:
-
Darrollh make sure your Datum structure makes sense also. Or you could end up with sh_it like this. because of pi_ss poor engineering.
...Leave a comment:
-
sometimes your MAX and MIN can be both Negative numbers or even both positive numbers and your result would be in your MEAS the highest of the 2. again... -
As You can see in my example my Max is +.0003 to much material but still in tolerance of my +.010 and my lowest point in my scan,...Leave a comment:
-
How About doing an alignment after each feature. Instead of doing it all at once. That way you can see how your Trihedron acts each step of the way....Leave a comment:
No activity results to display
Leave a comment: