RandomJerk
Ultra Senior Member
Joined: 11-15-2013
Location: I don't know
-
What probing system are you using? If you're using a TP20, you're really not that far off, particularly if you're using a module with too high of a triggering... -
Auto retract is a Sheffield controller function, so anything from that architecture (including UMP360) should be able to do it.Leave a comment:
-
^^^^ This
If your current value is less than 1, change it to 1 and see if it looks and performs better, then start increasing or decreasing it by... -
Another thing about the cylinder - you're only measuring ≈22°?
Code:START ANG=245.7858,END ANG=267.8173
Leave a comment:
-
Given datum C is a circle "out in space", what's the issue? What does that mean? The datum is in space, the machine is trying to go to space....Leave a comment:
-
Yes.
...Code:PLN1 =FEAT/CONTACT/PLANE/DEFAULT,CARTESIAN,OUTLINE,LEAST_SQR THEO/<0,0,0>,<0,0,1>Leave a comment:
-
Ah, in that case they should have provided info. I think you'll find many are gun shy about these things as more often than not they come up long after... -
I'd personally be reluctant to send the information you're requesting unless the requirement was stated at the onset of the project and customer guidelines...Leave a comment:
-
Mike Ruff - you're welcome, but you won't be thanking me after your first few attempts at quick fixture mode
It works OK once you screw... -
You can't have zero in two different locations.
Have you worked with quick fixture mode? You want to be in quick fixture mode, then you...Leave a comment:
-
Looks like they're basically asking for the Z value of the radius center. As JEFMAN said, use FIXED_RAD, it's the only possible way you'll get a repeatable...Leave a comment:
-
AAP_CMM You don't select the radius, you enter it under "Spacer", one of the tabs at the bottom. -
@andersl Think we were responding at the same time, I jut got distracted by coffee before I clicked post...... -
MOVE/ALL, not supported on certain controllers. When you look at the syntax, it's asking for an XYZ, and I forget if it's the XYZ of the current tip or...Leave a comment:
-
Change one character to lower case inside the [code][/code] and it will go in as all (except for 1) caps, you won't even need to include a comment. -
1) If the scans are set to MASTER, you don't need the CAD for what you're describing. Rather than delete it, though, I'd just rename the .CAD file, all...Leave a comment:
-
I had an issue in the past with a different machine in a different place that was caused by an incorrect speed (as AndersI noted above). Make sure the...Leave a comment:
No activity results to display
Leave a comment: