WolfMan
PC-DMIS Guru
Last Activity: Yesterday, 11:07 PM
Joined: 11-11-2013
Location: TX
-
You’re right Ninja, I was strictly talkig about outputing only perpend. -
I didn't see the pdf file at first, but yes, the construction of a A-C line should be changed to 3D Line. Even though proper alignment is important, To... -
If everything is done right, look into your calibration. I mean the sphere qualification. Re call your probes and angles and do a study and room temperature....Last edited by WolfMan; 08-09-2018, 10:18 PM. -
Lol... -
Its not the same as HTA. S is a cmm, this one is laser. -
Global HTA machines
Question for who run this bad boy, does it run on pcdmis or quindos only? -
If I understand correctly, per y14.5-2009 ONLY, when AVG dia is on the drawing it must be accompanied with a Roundness/Circularity?
what... -
Perhaps This is a job for iterative alignment?? Not sure what its called in Calypso.
No activity results to display
Leave a comment: