Check out this thread:
...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Looks like the angle of the "handle", just centered on the bore for some reason.
Leave a comment:
-
Then all you should go vote for the suggested idea I put in two years ago:
Unprotect Protected Mode while Program is Open / Hexagon Measurement Systems / HexagonMI Idea CenterAllow programmer to unprotect a program when program is ran in Protected Mode.Current State:In protected mode, if an operator runs a part and the part is out of spec or there needs to be further analysis, the programmer has to close out the program, unprotect PC-DMIS, then re-run the part to do the analysis.Real-life situation: Program was ran in Protected Mode and flatness was out of tolerance. In order to add graphical analysis to the report to see "where" the high and low points are, I need to close out the program, enter the password to unprotect the program, then open the program again, add the graphical analysis, save, then rerun the part.Future State: To save the steps and time,it would be nice to have the ability to unprotect PC-DMIS when the program is still open, add the necessary adjustments, save, and re-enter Protected Mode.
- Likes 1
Leave a comment:
-
I guess I am not sure what you are referencing.
Are you saying you need to go darker than 95-100%? If so, I do this quite often with SensiLight...
Leave a comment:
-
No. We run into the same issue. Not all too often, but if I want to dig into the XYZ's of the matter, then I need to re-run the part to see the raw d...
Leave a comment:
-
Did you update the framegrabber drivers? When I upgraded from 7 to 10, I had to get those from Doug S at Hexagon.
Leave a comment:
-
That'll do it. If you do not have the correct settings or licensing, it will turn off your lighting. I had that issue with my offline seat. I updated...
Leave a comment:
-
Lukas Yes, that makes sense....
-
Format/Text to show the MAX and MIN deviations. That will help you understand the profile calculation better....
- Likes 1
Leave a comment:
-
I believe they are. There was a "goof up" on Hexagon's part that didn't allow that SP to work with 7, but I believe they fixed it in the later...
Leave a comment:
-
Maybe take a look at fixturing? Is it consistent? Is there is a wall thickness issue around the part?
Test out the leveling factor by taking...
Leave a comment:
-
-
-
I do not think I have seen that issue before either. Your machine interface settings didn't get messed with, did they?
Do they work correctly...
Leave a comment:
-
That worked. Thank you.
Another question, are we not able to create new topics or comment on posts in that forum? I tried commenting that...
Leave a comment:
-
I can't even d/l the software. I have access to the forum section, but when I click the "download here" link setup by Don Ruggieri , I get a...
Leave a comment:
-
-
As far as I know, that is how it runs. The only way around it would be to loop it within the program for it to append to the same report without the page...
Leave a comment:
No activity results to display
Show More
Leave a comment: