Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
No worries, JaredHess! I managed to reach out via the Yes/No question and it's getting fixed!...
-
How did the customer check it? Contour machine? CMM? Vision? Shadowgraph? Gage?
Leave a comment:
-
Eyeball the calibration for the angled tips and make sure the probe touches the sphere and nothing but the sphere....
- Likes 1
Leave a comment:
-
Dammit... 3-4 000 €
-
Wouldn't it be enough to call the MS-DOS command MKDIR as an external command and pass the folder that shall be created as argument?
- Likes 1
Leave a comment:
-
Ok, thanks Henniger123
-
I don't know of a ISO 1101 version of surface profile that allows for that kind of tolerancing that "shrinks". The "between" A<->B...
Leave a comment:
-
Have you tried using them seagull brackets ( { } ) instead of the hard brackets ( [ ] )?
...or tried with a variable instead of number?...Last edited by vpt.se; 06-21-2022, 06:53 AM.
Leave a comment:
-
Did you check the logs from the installer, it should be able to tell you (or them) what went wrong.
Leave a comment:
-
If you use the "Test" scenario, you will only get the properties that are in the feature (diameter, xyz, vectors) and what is shown in the status...
-
I would prefer if PC-DMIS kept the "original" scan data (raw) "somewhere" and performed any filtering using this data, but presented...
- Likes 1
Leave a comment:
-
[2022.2 SP1] Changing filter/UPR (adaptive scan) forces you to remeasure the feature
Changing filter in the adaptive scanning dialog, will cause the subsequent results to be zeroed, requiring you to remeasure the feature in order to get...
- Likes 1
-
-
Check your F5 warnings. They did fix this in the latest release:
Have not tested your sample yet....
Leave a comment:
-
-
Screen is Z, looking down on the part, B-C direction Y, D-E direction X:
B-C will have a plane in direction X.
D-E in direction Y....
No activity results to display
Show More
Leave a comment: