Schrocknroll
PC-DMIS demi-Guru
Last Activity: Today, 02:42 PM
Joined: 03-01-2006
Location: CT
-
Do you have any of this accomplished yet? Assigning a path to a variable using the S/N input from an operator, then printing to a file using that variable... -
If you have another probe set as the Master and you've built the probe correctly, you should be able to simply answer No the sphere hasn't moved and use...Leave a comment:
-
You are correct, this has been largely discussed to death.
I would like to say that there are ways of emulating the lack of constraint on...Leave a comment:
-
If it wasn't for the .001 and smaller tolerances mentioned you may be right about the Romer. If you need that accuracy, a portable CMM isn't the way...Leave a comment:
-
Thanks, makes sense. -
By "end point of the feature" do you mean the last hit or where the probe ends up after the last hit including the retraction? Either way that's...Last edited by Schrocknroll; 06-10-2019, 05:32 AM.Leave a comment:
-
You could try measuring the circle with hits and align to it, then the scan should be right on the money.Leave a comment:
-
programmer I don't believe there is a way to. -
When filling out a report when there is only one characteristic(balloon) number I will put the worst deviation. For the CMM report I always have all...Leave a comment:
-
In PC-DMIS or on the forum? In PC-DMIS the line extends out all the way to the end. It only breaks it up into several lines when posting it here. -
You could also place a can of marbles at the edge of the CMM. At the end of the program have the probe head move into the can and spill the marbles....Leave a comment:
-
It seems a little counter intuitive when you first hear it, but as Mike said, the smallest circle inside an I.D. is the Max Inscribed. Think of it this...Leave a comment:
-
programmer It's not allowing you to what? Can you create an array at all? Are you only able to add a certain amount to the array? I'm unclear as to... -
programmer I did it manually. I typed out the first line and then added the second line to add a 16th item to the array. -
Pony up to update the SMA and upgrade. It'll be expensive, but the only way to add CAD++.Leave a comment:
-
Selecting "fit to datums" creates an alignment within XactMeasure using the datums and reports the position relative to that alignment. If...Leave a comment:
-
Be careful with that. Thread depth is depth of usable threads, e.g. the depth a thread go gage will go. Just using the CMM to check for the presence...Leave a comment:
-
Do you have another version of PC-DMIS installed? Maybe you could back save it to another version and try exporting it from there.Leave a comment:
-
Kills two birds with one stone. It stops the CMM and tells the operator what he should do....Leave a comment:
-
There is a similar box that states that probe tips are being used that haven't been calibrated the same day, or something like that. You can set a number...Leave a comment:
No activity results to display
Leave a comment: