Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
(vector point snafu all over again)
-
do you get the same numbers for the 90,-90 every time you calibrate it or do they change each time? If it always checks 0.0250 in Y, then it should be...
-
IT had an internal ID-10-T issue
-
pretty sure it has a good, clean bill of health. Yes, it takes a LONG time to do this (almost 7 hours today) but I have a very high level of confidence...
-
linear line charts (still in inch)
...
-
Table flatness: +0.00051 to -0.00071 (0.00122 'flatness')
Ball Bar: +0.00020 to -0.00024
(all values are in inch)
starting the step...
-
I think that MAY depend on the controller. There are times when I can NOT hit the machine start button and get any response until I open Pcdmis and then...
-
-
I am currently doing my "is the CMM still happy?" checks on the Global.
STEP 1: Using the most common probe build, I calibrate...Last edited by Matthew D. Hoedeman; 06-21-2022, 07:40 AM.
- Likes 1
Leave a comment:
-
A type 1 study uses 6 STDDEV. https://support.minitab.com/en-us/mi...-system-analys...Last edited by Matthew D. Hoedeman; 06-20-2022, 09:44 AM.
-
max(group of cells)-min(group of cells) in Excel
Or, just take the highest reading minus the lowest reading, that is the variation (aka RANGE)....
- Likes 1
Leave a comment:
-
DEPENDING on what you change in the F5 setup, if Pcdmis can't write to the registry, whatever you changed IS NOT going to be changed, so it is like you...
-
-
-
Everybody makes mistakes. Even I made one. Once. (when I decided to do this for a living)
-
Oh he|| no! We need to leave it here for laughs!
No activity results to display
Show More
Leave a comment: