VinniUSMC
PC-DMIS demi-Guru
Last Activity: Today, 11:15 AM
Joined: 04-04-2013
Location: Holland, MI
-
Open in Word. Save as PDF. Use 3rd party (https://cloudconvert.com/pdf-to-rtf) to convert back to RTF. Seems to work. -
Case #00259712 -
neil.challinor I sent you an email.... -
Ok, yes. I figured out that the report I needed to use is the "Default" report button. This allowed the "Use text mode dimension reporting"...Last edited by VinniUSMC; 03-30-2021, 07:36 AM.Leave a comment:
-
Why is "Text Only" report not actually text only? Why is there a report call "Default"? And a "Set Default" button?
...Leave a comment:
-
Ok, I'm to the point where I have a report that looks similar. Now I just need to hope I can convert the wonky files.
Yes, AMYUNI set to...Leave a comment:
-
I will look into this converter. I noticed that Word will allow converting to ASCII or Unicode, and what it output then was text, 1 character per line...... -
Let's see if this is faster than support, and/or the other side.
Leave a comment:
-
Leave a comment:
-
2020? printing problem
I went to our 2nd facility, and had to use their fresh, never touched install of 2020 R2. The report window was set to print only text, and print to RTF.... -
The CMM here hasn't run, at all, since the last calibration (several months ago) when they also got a new computer and "upgraded" to 2020. -
Yeah, I fixed it because of you D Wade. Thanks -
The machine interface was set to 50 max for all 3 axes... lol -
This fixed it. -
It reads 50, until I change it. Then, when I execute the program, the machine still runs slow. And, when I check the settings again, it has reverted to... -
Yes, I do have access to the Registry. -
Machine speed problem
I am over at our other facility running a Brown and Sharpe CMM with one of the giant controllers. The PC was replaced along with an update to PC-DMIS...Last edited by VinniUSMC; 03-22-2021, 09:07 AM. -
Treat it as though it is all being projected onto a plane that is constructed from the 4 A points. Iterative will work, but only if the major axis is...Leave a comment:
No activity results to display
Leave a comment: