Bevel Gear Wheel

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Bevel Gear Wheel

    I need help

    I have a bevel gear to measure.
    I'm not sure how to do it.

    I think the SPIRBV command were to be used here.
    Only the license for GEARBV is not available.

    but can I check this without a GEARBV license?

    usually I can only check the pitch or, but it will be necessary to create a parts program for it, right?
    Maybe someone already has a part program for pitch or spiral teeth here?
    Attached Files
    Tags: None
  • #2
    Gear commands won't work for you if you don't have that part of the license purchased from Hexagon.

    Comment

    • #3
      Hmmm, good to know ! so quindos would be a a better alternative than gear ?

      Comment

      • neil.challinor
        #3.1
        neil.challinor commented
        07-09-2020, 11:26 AM
        Editing a comment
        Quindos has many, many more gear options than PC-Dmis and can pretty much check any type of gear, rack, spline, worm or coupling you can think of (providing you purchase the required license option). PC-Dmis gear only supports straight or helical spur gears - we dropped support for bevel gears back in 2016.
    • #4
      what about "hob" inspection ?

      Comment

    Previous template Next

    Related Topics

    Collapse
    • DHoye
      Master Gear Pitch
      by DHoye
      Because I'm a rookis this may seem like a dumb question, but has anyone ever checked a master gear pitch on pcdmis 4.2 and if so could you explain the...
      02-26-2008, 12:43 PM
    • jcombs716
      Helical Gear
      by jcombs716
      I have a part that i have PC_DMIS conduct an Alignment then go into PC_DMIS GEAR, when i create the program i enter all the data from the drawing including...
      10-07-2020, 08:26 AM
    • Vic Watson
      Pitch diameter of a bevel gear??!?
      by Vic Watson
      I haven't done gears before so, they dump a bevelled gear on me. How do I get the pitch diameter (pitch cone?) of a bevel gear?
      02-25-2012, 11:11 AM
    • PowerJunkie
      finding a tooth
      by PowerJunkie
      I'm working on a clutch which on it's face has 120 teeth at 10 deg each side.
      The teeth are not clocked to anything, so every part is different....
      10-27-2008, 12:19 PM
    • jamshed
      Pitch Circle Diameter
      by jamshed
      Drawing calls out for PCD for a gear. How do i get it using measured hits or Auto Feature ? Do i need to create a circle ? but which features would i...
      04-26-2016, 10:18 AM
    Working...
    X