Tweet
Hey all, long time CNC programmer here, first time PC-DMIS NC user. I am looking to get my feet wet using this software to create on the machine inspection programs for the shop. Managers will be sending me to some training for this software, but in the meantime, I would like to get a head start on getting used to the interface, etc. Where would you point a green operator to learn the basics of importing models, orientating them correctly, and basic programming. Any help would be appreciated.
-
Hello, I am a new member to the forum and would like to ask a question. I have been in Quality for approximately twenty years and have been a CMM programmer...01-07-2010, 01:25 AM -
Hello PC-DMIS folks, I have been operating our CMM for about 4 years now, but my programming experience has been very limited. I am very experienced with...11-19-2013, 02:18 PM
-
I just started learning the software and am working with a Brown and Sharp CMM, Leitz scanning probe head...I may not have the names and terms down yet,...01-31-2013, 03:57 PM
-
Hi everyone
I'm new here, my company bought a Machine Type: Brown & Sharpe MVAL PFX 454 at auction and the auction company wiped the pc. I...08-20-2009, 08:20 AM -
Hello,
Last week I was moved into Inspection b.c our Inspector is leaving this Friday.
I have basic knowledge of the CMM....06-25-2012, 05:45 PM
Comment