Tweet
Gears with touch trigger probe
Is it possible to use the Gears software with a standard touch trigger probe, instead a scanning probe ?
-
Jpc-Dmis
-
Yes
Yes, it is possible. I do it that way frequently. It will run a bit slower because it has to touch every point in the scan if you ask for profile or lead angle data, but it works fine. -
use the Gears software with a standard touch trigger probe, instead a scanning probe ?Comment
-
-
Is it compatible with all probe heads?Comment
-
I've been writing this rather long program and I'm down to my last 2 outside diameters. But for some reason the probe won't trigger on them. I'm not...12-15-2008, 01:07 PM
-
How do I determine the actual touch force of the probe to the part during measurement?
07-07-2006, 11:56 AM -
I am measuring a flexible part that I can't support. I'd like to reduce the trigger force to get accurate result and to make sure the part doesn't move....02-14-2008, 08:47 AM
-
Hello out there!
I have been programming this die. I start with the continuous probe head and half way through the program switch to a touch trigger...
09-07-2006, 02:50 AM -
It seems to me like my probe takes to hard of a hit on whatever surface it is reading... what should normal max,low force be? or trigger force?
...10-03-2014, 08:37 AM
Comment