our nightshift guy had a bad crash yesterday... we replaced the tp2 and tip today and went to calibrate our tips and had no issues. When I did a part check pcdmis reports the part out by 1mm when its really not out..... here's the twister.... ill check a different job and i have no issues... ???? any ideas?
Probe problems
Collapse
X
Related Topics
Collapse
-
by firehausHi All,
We just installed mr1 last Wednesday and noticed some calibration issues. When calibrating any tip angle up to 85 degrees in the...-
Channel: PC-DMIS for CMMs
12-18-2013, 02:22 PM -
-
by oddamI have a Excel 12/30/10 using Pcdmis 4.3 mr1. When I calibrate my probes, no matter if it's a star, or just a single probe, my probe diameters, and now...
-
Channel: PC-DMIS for CMMs
11-04-2009, 07:55 AM -
-
by gszpotI am having problems calibrating a LSP-X1m probe. The LSP-X1m probe is for tips that are longer than 100 mm. When trying to calibrate an A0B0 tip i get...
-
Channel: PC-DMIS for CMMs
02-05-2015, 05:03 PM -
-
by SkullbusterI have a rack with 4 probes on my Global 07-10-07 CMM. Everything was fine until probe 2 started crashing. Performed a reboot, recalibration, etc, etc...
-
Channel: PC-DMIS for CMMs
10-24-2016, 04:19 PM -
-
by kalepitohello
i have a problem when realize the calibration of this tip the others doesn't have have problems
always standar deviations for probe...-
Channel: PC-DMIS for CMMs
11-21-2013, 12:11 PM -
Comment