sample hits

[dwade]

Can I pull sample hits from an autocircle? I've looked and looked and cannot find out how to do it. I can pull the individual hits from the cirlces but can't find anything on getting the sample hits.

TIA

Duane

[cmmcaliguy]

sample hits

Well if you think about it, your "sample hits" are at a given distance from the center of the circle, that is, if your using "auto circle". You should be able to do the math to find the hits.

[inspector212]

It's in the probe toolbox(V4 and up). Change sample hits to 0.

[dwade]

It's in the probe toolbox(V4 and up). Change sample hits to 0.

I know where and how to do that....

I want to pull the individual points from my measured sample hits to construct a plane from those points. I've got 3 bores in line all relative to the same surface and wanted to get sample hits 1 and 2 from the first bore and sample hits 3 and 4 from the 3rd bore to construct a plane on that surface.

[inspector212]

Sorry, I should have read your post closer. I don't know of a way to do that. Why not just take extra hits on the surface?

[bw_bob]

Say your measuring in the z+..I would think your sample hits would be whatever your z reading is.....measure the circle using sample hits & extract the z reading........