IDTF: Move command while not in automatic mode

[ag1979 Member Find all posts View Profile Close ag1979]

I know I've run into this problem before. I have been running this program for a few days now without any issues, until just now. This program was running fine but now it starts giving me an error:

IDTF: Move command while not in automatic mode

Any ideas?

[Matthew D. Hoedeman has received PC-DMIS total consciousness Find all posts View Profile Close Matthew D. Hoedeman]

That is because you are using V3.7xx and you have a READ POSITION (like for a hole) for the first feature AFTER a tip change.