problem with repeatebility

[Lionheart1º]

Hello!
I'me facing a problem with some measurements, like this:
I've measured a production of 5 + 5 parts, in all parts i've foud some dimensions perfectly iqual, like 23.674, 23.674,...,23.674, this dimension is a radius, i face the same problem in a angle, and some distances.
Now, i dont think this is possible, but it happens, whats your opinion?
The parts where measured on gauge.

[craiger_ny]

Sounds like something is not marked.

[AJHVW93]

Delete and remeasure features. I heard of this problem before and ran into it for the first time about a week ago.

[Matthew D. Hoedeman]

Try clicking on the REPORT MODE icon after you are done measuring, see if you get different values then. One (or more) versions of Pcdmis had this as an issue.

[Paul Sarrach]

wcs

[Cumofo]

Try Running the Whole Program from the execute Icon or "CNTR0LL + Q".


G

[rangerboat72]

What everyone else said...

[cmmguy]

wrb72s

[RClone]

I had it reporting dimensions and features it didn't measure,they where skipped.
It just kept reporting the last numbers it had over and over.
I had to remove them and the re enter.

[tking]

Nice buck Ranger! October 1, can't wait!

TK

[rangerboat72]

Nice buck Ranger! October 1, can't wait!

TK

Thanks TK!

That's the only thing I hate about UNMARKING a feature. When it reports, the ACTUALS match the NOMINALS. If you are going to skip a feature, you might as well UNMARK it before you EXECUTE. Just be sure to UNMARK the DIMENSION also...