Tweet
I heard that with a CMM concentration is a result of 114% of the allowed tolerance. Something about diametrical vs radial, and so true position is much more accurate. I also heard that the length of a cylinder must be longer than the diameter when checking concentricity of cylinders...any truth to either of these? If so what is the perferred method?
-
I know true position has been discussed before. But I still don't quite get it after reading these discussion. When I tried to find the true position...05-18-2010, 08:21 AM -
This is what I have. I'm not seeing this happening. I have two rotations, which is no problem. Just don't have any basics after that. And I've never TP'd...11-15-2017, 03:34 PM
-
Can any one Help me
To understand the position tolerance with out diameter symbol and with diameter symbol.08-20-2016, 12:30 PM -
Hi. Could somebody explain to me how to apply Axial feature on cylinder true position. I have read on Reference manual, but I did not get it.
...04-22-2006, 03:50 AM -
Good Morning,
Question : I was measuring critical features off a fixture that a customer wanted data on and came across something pcdmis...05-20-2006, 06:31 AM