Talk about Crash'O'Rama!
-
Sheffield Calibration Problem in 4.2 MR1
We are having Problems with our Sheffield machine During Calibration. When we Calibrate Tip A0B0 the machine will stop before the last couple of points and go into manual mode and we have to put it back in Auto mode to finish the routine. Also if we have more than one Probe Rotation to calibrate it will change the Probe diameter resluts to something above .200 inches on a .076 (2MM) Probe in several of the other Rotations. Any Thoughts on this? We Tried to go back to 4.1 and it now does the same thing. 4.1 never had this problem before. Talk about Crash'O'Rama!
-
I have a sheffield RS-70 with pc-dmis 4.2 mr1. Our computer died and was replaced. I copied the hole hard drive to the new one and updated the registry...05-22-2009, 02:32 PM -
Just got one CMM back up and running when the other goes down!
Looks like the wire going from the switch to the Servo board dropped...06-16-2010, 03:40 PM -
We are preparing to purchase PCDMIS and a Sheffield D28. Anyone have experience with this machine's performance
and how it does with the softw...
01-26-2007, 03:18 PM -
We recently had one of our machines re-calibrated. Ever since the BnS guy left, our usual electrode checking system hasn't worked. Basically, we have...07-15-2008, 02:00 PM
-
Hi All,
We just installed mr1 last Wednesday and noticed some calibration issues. When calibrating any tip angle up to 85 degrees in the...12-18-2013, 02:22 PM