• Filter
  • Time
  • Show
Clear All
new posts

  • Error

    Good morning,

    Came in this morning and started our B&S 7-10-7, running 3.7 mr3 and during the homing cycle it came up with a TR_FG102.Z COUNTER ERROR. Is the fix within our realm or is it a B&S problem?

    Thanks for your response


  • #2
    Just a shot in the dark, but did you clean the scales?
    sigpic 1.61803399Δ


    • #3
      Yes, we cleaned the -Z- axis.


      • #4
        Is it an Xcel or a Global? If it is an Xcel, the pads may have been worn on the reader head. In that case, cleaning won't help. Only fix: call B&S.

        PC-DMIS/NC 2010MR3; 15 December 2010; running on 18 machine tools.
        Romer Infinite; PC-DMIS 2010 MR3; 15 December 2010.


        Related Topics


        • Kevin Watts
          emergency error
          by Kevin Watts
          has anyone ever seen this emergency error. my cmm came on fine this morning and during calibration of tips it stopped and displayd this error.
          07-30-2007, 10:48 AM
        • rrioslm
          Axis Z error
          by rrioslm
          Hello guys, i'm not sure if this thread was discussed before, this is my first time here and I have this problem with the machine. The CMM that we are...
          06-23-2015, 08:29 PM
        • mx07423
          TR_FG100,X Counter Error
          by mx07423
          We have been getting this error off and on for the past week. It happened four times yesterday alone. We have cleaned the scales and all of the slides...
          09-28-2015, 05:30 AM
        • Ravenmaniac
          Amplitude Error
          by Ravenmaniac
          Good afternoon everyone. We have as one of our CMM's, a "ONE" machine and as of late as we crank up the speed of run of any of the proven PCDMIS...
          09-04-2013, 04:36 PM
        • arock
          overspeed error???
          by arock
          Curious if anyone has ever got this error... and wondering what you did to fix it???
          09-07-2018, 12:45 PM