Old version program w/ Ph9 wont run Tesa probe?

[Paul Sarrach]

I am trying to run a program written with Ver 3.5 and a Renishaw PH9. I am running Ver 4.2 with a Tesa probe. I changed probes in program and it is give me a "TR_MinM2.Machine.Parameter Larger than Premited"

So then I try with a manual hit. It just sits and the hour glass just tumbles and tumbles? Why won't it work. As a quick I copied and pasted in a new program and I can get it to work What gives?

[Matthew D. Hoedeman]

That would be the "migration' effect. Migrated programs (UP or DOWN) have LOTS of hidden issues.

[Paul Sarrach]

That would be the "migration' effect. Migrated programs (UP or DOWN) have LOTS of hidden issues.

So what you are telling me is to open it up in Spanish?

[Matthew D. Hoedeman]

Sure, why not, it can't be any worse, can it?

[cmmguy]

What are the angle increments of the Tesa probe (Spec speaking) as compared to a Renishaw?

[Paul Sarrach]

What are the angle increments of the Tesa probe (Spec speaking) as compared to a Renishaw?

I went in and changed them. Did not work

[cmmguy]

I went in and changed them. Did not work

Did you ever figure this out... seriously.

[Saliha]

Hi Paul , if you suspect the probe head angles , try to use mark used command.
But I suggest to check the parameters for the speed if it is mm or % ... if your current speed parameter is about mm/inch and the part program contains % , you may get an error msg.

HTH
Saliha