Operator Mode w/Bladerunner

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Operator Mode w/Bladerunner

    I posted this on the Blade Inspection board but I thought I might get more of a response in here.

    We are running 3.7 mr2 and I'm wondering if there is a way to run bladerunner using operator mode, or if the programs are made read only will we have problems getting them through bladerunner? All of our programs are run by operators on the shop floor using bladerunner and we have recently had problems with unauthorized changes being made. Also, each part runs 2 consecutive programs and during the changeover from one to the other I've noticed that the program can unknowingly be changed if I am typing in an office program. I need to find a way to protect against these issues. Any ideas?

  • #2
    I sent ya a PM
    Which one gets ridden today? MPH vs MPG..tough choice, both are FUN
    sigpic

    Starrett RGDC 4028-24 :alien:
    Demon vintages 3.7, 4.1, 4.2, 4.3, 2009

    Comment

    Related Topics

    Collapse

    Working...
    X