Tweet
We run PC-dmis version 3.2061 on an old computer running windows NT. If we were to get a new computer would the old pc-dmis program work alright?? If not, whats the newest operating system that my version of pc-dmis will run with? thanks
-
-
Hello,
I went thru the same situation a cpl years ago and if I can remember right, we had to download new drivers and an additional driver for the comm port. That one was at alladdin (sp?).com. We used XP Pro on the new comp. Don't forget to make a copy of your files that are needed for the PC DMIS software, (probe etc)
A.Goresigpic
A.Gore -
thanks for the info! Did you notice any improvement running it on a faster machine???? or was it pretty much the same? thanks again.Comment
-
sigpic
Originally posted by AndersIComment
-
3.2 was a good version and had very little problems. As for the speed, that is dependent on your comp hardware (graphics card, ram, processor) and the size of your cad models.
A.GoresigpicA.GoreComment
-
I’m using PC-DMIS v3.47, the computer system came with the CMM machine at time of purchased (6 years ago), we planned to buy a new faster computer,...04-30-2010, 03:49 PM -
We had to change the computer for PC-dmis today due to computer warranty policies in the company.
I changed the HASP key from the old computer...09-20-2011, 12:37 PM -
Hello all. Thanks for reading my post.
Our CMM computer is dying a slow death. I have been defragging and running system mechanic to keep...05-10-2014, 09:40 AM -
I just installed new PC-DMIS on a new computer, moved all the needed files, and installed new driver for my usb-to-serial with no driver error.
...06-24-2015, 02:52 PM -
The Dell that came with our arm is XP based and that is of course expiring so we want to upgrade. Any recommendations? Also, PCDMIS was pre loaded on...03-31-2014, 12:00 PM
Comment