Surface Point Comp.

[J Temmen]

Hey Guys,

Don't know if I missed a setting or what but when I measure a surface point with 3 sample hits it with a guessed vector of 0,0,1. It appears to measure correctly and show an actl vector of aprox. 0.09,0.07,0.996, the problem ithat when I report the T value it matches the Z deviation exact. Shouldn't it be slightly off?

[BSchwark]

If your T value and Z vector direction is close your values will be very close.
How many decimal places are you reporting?


BS

[Bill **********]

Do you have snap turned on? If so turn it off.

[J Temmen]

The vectors are different to the point that the deviations should be about .03mm different and no, I don't have snap turned on. Could there be a setting I don't have turned on that takes care of this?