Might be a stupid question but .....
How can I Verify on the Cad, that I rotated the correct direction (+/-) after a cad=part ?? I created a offset point (0.065mm) in the "Y" and rotated to it then did a cad = part but wanna make sure it was in the correct direction.
Tia
How can I Verify on the Cad, that I rotated the correct direction (+/-) after a cad=part ?? I created a offset point (0.065mm) in the "Y" and rotated to it then did a cad = part but wanna make sure it was in the correct direction.
Tia
Comment