Check your depth of the points and make them all the same. Just a thought?
BS
-
Maybe a silly question, but are you in the correct working plane during the construction?
Leave a comment:
-
construction of a circle from vector points
I cannot construct a circle from vector points. Why is that? I used polar mode to easily even space the points and there is some problem with that. The diameter is close but the form is incorrect by 2.5 or 3 millimeters
-
Hi,
Is there any way to combine two sectors in one circle ? I'm a bit lost there..
Thanks !03-11-2014, 02:25 PM -
This is my first time posting and I appreciate any help you can give me.
When I construct a circle out of points that have been created...04-22-2010, 05:58 PM -
I have a part with a groove diameter that is interupted by two pockets 180° apart so I can only measure about 100° on each side of the pocket. What...03-12-2008, 10:21 AM
-
I Just don't get it. I am manually programming this part. I took 6 points on a radius. I labeled them as points only. Then I chose to contruct...
01-16-2008, 08:22 PM
-
Good morning.
I have a program with approximately 6,000 move points in. I was wondering if someone VB GURU out there??? could change these...09-08-2006, 07:03 AM
Leave a comment: