Hi,
Is there any way to combine two sectors in one circle ? I'm a bit lost there..
Thanks !
-
03-11-2014, 02:25 PM -
This is my first time posting and I appreciate any help you can give me.
When I construct a circle out of points that have been created...04-22-2010, 05:58 PM -
I have a part with a groove diameter that is interupted by two pockets 180° apart so I can only measure about 100° on each side of the pocket. What...03-12-2008, 10:21 AM
-
I Just don't get it.
I am manually programming this part. I took 6 points on a radius. I labeled them as points only. Then I chose to contruct...
01-16-2008, 08:22 PM -
Good morning.
I have a program with approximately 6,000 move points in. I was wondering if someone VB GURU out there??? could change these...09-08-2006, 07:03 AM