v4.1 flipping vectors fixed?

[Underspec]

Is this fixed in v4.2? It's very annoying

[Wingman]

Is this fixed in v4.2? It's very annoying

Just curious if vector flip on NEW programs written in 4.1 or on programs that have been written on earlier cersions?

[Underspec]

Vectors flip when you redo auto features.

[validations]

Running 4.2
Its still flipping vectors.
good luck

[JamesMannes]

Running 4.2
Its still flipping vectors.
good luck

I must have the perfect machine/controller setup, and the only good versionb of PC-DMIS 4.2, because I have almost no problems with this version?

[validations]

Maybe the only perfect machine setup, are you using cad??

[JamesMannes]

Maybe the only perfect machine setup, are you using cad??

That's pretty much all I use.

[Underspec]

I heard it was fixed in 4.2. Maybe it's machine specific?

[validations]

DCI issue maybe? SW or "scan to point" build issue maybe.
Creates one point correct, then the remainer of the point build is reversed.
Happens about 25% of the time.. and 25% too much.
We do reverse engineering here, we scan everything.