composite profile

[Bob Pierce]

V4.1
I need a bit of clarification concerning PCDMIS and composite profile.
I have a FCF with: .50MM profile to datums ABC over .25 Profile no datums.
The feature being inspected is a feature of size.
I interpet that as being a location ( upper callout ) over a refinement of form ( lower call out ).
When using the dimensioning window I place a datum into the call out. PCDMIS offers form and location. I am confused on how to dimension a composite profile FCF. How do I report this call out?
Thanks forum

[JamesMannes]

See page 11 of the linked document

GO HERE

Hope that helps you.

[Bob Pierce]

Sorry but i can not get to the page. the site has been blocked "personal Storage something or other"
Is their a chance you could Email or post the page?

[JamesMannes]

Sorry but i can not get to the page. the site has been blocked "personal Storage something or other"
Is their a chance you could Email or post the page?

Look at your PM's (Personal Messages)

also, try it once again, it was a bad link(I fixed it).

[Bob Pierce]

Still could not get it
I made a reply to the email

[Paul Sarrach]

I got it to open. I never saw that one, thanks.

[Jan d.]

I rememeber that V4.1 the composite profiles did not work properly. I tried them in V4.2 and they do work as you would expect.


Jan.