Tweet
How do you simulate flipping your cad model 180 in z? I can flip the model, but my probe flips with it? Can I flip the model, and not the probe?
-
Aaron Fenner
Quality Engineer
PC-Dmis v4.3
B & S Global Status 7.7.7
6 years xp 32-bit
sigpic -
Try: Hit F5 -> Part/Machine-> Adjust
HTHsigpic
Either seem as you are or be as you seem.M.J.Rumi -
measure the z+ plane first in off line mode as it sits on the table, then level z+.
run program up to that point, it should be right.
gsigpicComment
-
Like in the post subject. How to compare real model measurment against imported cad model. ?09-08-2010, 01:42 AM -
I have a cad model that I have imported into my Pc-Dmis program.
Someone has saved the model set at an odd angle.
when I do my alignment...06-25-2008, 03:39 PM -
I haven't messed with the CMM models much, but from what I can tell the relationship between the CMM and CAD models is a codependent one. Ideally, I'm...06-04-2019, 12:20 PM
-
Using v4.1 after importing cad file and positioning the coordinates to location on model I positioned the probe over the part and it show on the model...07-12-2014, 10:13 PM
-
I have a test part that I have been trying to set up on the cmm. I haven't had much time to work on it due to other things that need completed first....01-28-2010, 09:47 AM
Comment