[2019 R1 SP11] Remeasure doesn't work when using adaptive scanning?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • [2019 R1 SP11] Remeasure doesn't work when using adaptive scanning?

    Like the title.

    Adaptive scanning, cylinder, remeasure on. Measures the cylinder once, then moves on to the next feature.
    My expectation were that it would measure it once, perform some kind of internal alignment to the feature and measure it again?

    EDIT: Default strategy works fine, measures twice, adaptive scanning - no.
    Last edited by vpt.se; 04-15-2021, 09:29 AM.
    PC-DMIS CAD++ 2o19 R1 SP11

  • #2
    Maybe because the default strategies can produce different results depending on the # of hits / rows..?? not necessary with scanning? Did you try anything other than Concentric Circle scan?
    sigpicTAU ALPHA PI INDIANA DELTA CHAPTER
    "Due to the highly confidential nature of my job, I am not allowed to know what I am doing" - author unknown

    Comment


    • #3
      This is a known issue. I cannot address any potential resolution at the moment.

      Comment


      • KIRBSTER269
        KIRBSTER269 commented
        Editing a comment
        Top Secret?

    • #4
      Thanks, Don.
      PC-DMIS CAD++ 2o19 R1 SP11

      Comment

      Related Topics

      Collapse

      Working...
      X