Yeah, I think it's gonna be a rough week. I got it up now though. I just shut EVERYTHING down, waited (had a smoke), fired it all back up and voila! For now anyways.
CMM Programmer
Jackson Michigan
Mistral 7.7.5
4.3MR2
I just bumped my probe head (first time in ages)and just got the same error message. I am sure I've seen this before. I just shut down the controller, leave it for a few minutes and fire it up again, no probs.
If I have offended anyone with this post, I'd like to take this opportunity to say BOLLOCKS
It is a machine overload error from the motor servo out of sysnc with the expected location. It is a time /distance formula. If it keeps showing up, a belt is bad or dirty.(usually)
It is a machine overload error from the motor servo out of sysnc with the expected location. It is a time /distance formula. If it keeps showing up, a belt is bad or dirty.(usually)
While working on a part, the machine stopped moving and had to be shut down in order to get it functioning. Attached is the error message I got. The probe...
Comment